Maxx-i CNC hopikamber M4W Wolverine MTW-le (uus versioon)

CNC Aluminum Hop-up Chamber M4W unit is precisely machined to perform accurately and consistently on HPA MTW Milspec, Forged, Billet and MTW-9 series. The Hopup Chamber M4W unit is built with an aluminum Rotary Dial Knob for fine hopup adjustments, the precision Hopup Lever and Bucking Nubs perform with R-Hop and Standard-Hop to keep the BB shooting accurately and consistently on every single shot. The Hop-up Chamber M4W unit is designed to accept the HPA MTW Engine M4 nozzle length, and fully compatible with most aftermarket soft and hard rubber buckings without losing FPS or dropping BB during use. The Hop-up Chamber M4W unit is wisely equipped with an interchangeable Inlet Adaptor to ensure the hop-up unit is inserted exactly in the center of the inner bore HPA Engine nozzle outlet without wobbling. Also mounted the removable CNC Brass Side Wings to slide smoothly into the outer barrel slots, and included an advanced CNC Delrin Locking C-Clip to hold the inner barrel tight in place without wobbling and twisting.

Komplektis :

1 x CNC Aluminum Hop-up Chamber M4W (new version)

2 x CNC Acrylic Side Cover

2 x CNC Brass 2.6mm Side Wing

1 x CNC Steel Pivot Pin

1 x CNC Aluminum Hopup Lever

1 x CNC Aluminum Soft Round Nub

1 x CNC Aluminum Soft Flat Nub

1 x CNC Aluminum Hard Concave Nub

3 x Steel Nub Spring

1 x CNC Steel Spring Guide

1 x Steel Upper Compression Spring

1 x Steel Center Compression Spring

1 x CNC Delrin Locking C-Clip

1 x CNC Brass Barrel Spacer

1 x Brass Barrel Spacer Holder Oring

1 x CNC Aluminum Rotary Dial Knob

1 x CNC Aluminum Inlet Adaptor

1 x Shim set

1 x Oring set