Elite Force H8R 6mm airsoft püstol

Laskerežiimid: üksiklask

Kineetiline energia [J] 1

Salve mahutavus [pcs] 10 kuuli

Laskekiirus [fps] 320

Toiteallikas: CO2 12 g

Kere: polümeer

Värvus: must

Hop-up: on reguleeritav

Soovituslik kuuli raskus [g] 0,2

Torupikkus [mm] 143

Kogupikkus [mm] 260

Kaal [g] 689

Tootja: Elite Force/Umarex, Germany

Modern style

TheElite Force H8R gen 2 6mm has a modern design inspired by contemporary revolver models. A durable polymer is used for the frame, barrel and outer barrel, which is coated with white powder paint.

The Elite Force H8R gen 2 6mm has been equipped with two 22mm Picatinny standard accessory rails, allowing for the mounting of a laser target pointer, flashlight, as well as a collimator or optical sight.

The modern design of the replica is emphasized by the high profile of the barrel with characteristic porting, and the anatomically profiled handle with non-slip texture.

The mechanical sighting instruments are enriched with fiber optics, which make it easier and faster to align the musket with the sights.

Locking trigger mechanism

The Elite Force H8R gen 2 6mm has an SA/DA trigger mechanism, allowing precise shooting with the cocking cock pulled back (single action) or dynamically using self cocking. In DA (dobule adction) mode, the trigger travel is longer and more force must be applied to overcome it.

Manual cocking in Single Action mode makes the trigger break (firing a shot) much faster and smoother.

CO2 power supply

The revolver uses an adjustable safety (in front of the cock), which, when activated, locks the trigger mechanism and eliminates the possibility of an uncontrolled shot during handling or as a result of a fall.

The Elite Force H8R gen 2 6mm is powered by carbon dioxide with a 12gCO2 capsule. One cartridge allows you to fire about 60 shots with a leveled initial velocity of about 100 m/s. The performance of the shots is mostly influenced by the air temperature, the dynamics with which you shoot and proper maintenance of the valves. It should also be remembered that aCO2 capsule (punctured) can be left in the replica for a maximum of 48 hours. After this time, the capsule must be removed or "fired".

Installation and replacement of the capsule are very simple, requiring only the removal of the lining, placing the capsule in the handle and tightening it with the pressure screw. This process is greatly facilitated by an Allen fixed to the cladding.

This simple solution means that the wrench is at hand all the time, thus avoiding the awkward situation in which we can't replace the capsule due to the lack of a tool.

The role of the magazine is played by polymer cartridges with a capacity of 10 bullets (2 magazines included). The loaded cartridges are placed in the compartment in front of the barrel.