Silent Industries Inferno nozzle V2 for MTW

The most important part when it comes to accuracy in HPA is the correct BB placement, SI found out that the stock MTW nozzle can be made longer to further improve the BB placement in the hop-up chamber!

This is why the Silent Industries MTW Inferno “Red” nozzle V2 was made!

Whats new with the V2?

• Multi Material design
• Less friction in the hop-up chamber due to the POM plastic nozzle tip
• Little bit shorter while maintaining the same BB placement, this results in improved feeding (not noticeable in most cases)

Key features:

• Improved BB placement, resulting in better accuracy. Depending on the setup, it can be very significant.
• Tapered nozzle end, ensures perfect seal with the bucking, POM Plastic end has reduced friction in the Hop-Up
• High-grade Stainless Steel and Self Lubricating Hard POM plastic

Short nozzles can cause vertical deviation between shots, when upgrading to this nozzle, you can expect less vertical inaccuracy!

Comes with a 5×1 O-ring for sealing with the nozzle base

To install you will need a 8mm wrench and a 5mm hex-key !