Specna Arms x Gens Ace 11.4V 1000mAh 50C HV LiPo Battery (G-Tech, Deans)

The Specna Arms x Gens Ace 1000 mAh 50C 11.4V High Voltage Li-Po (G-Tech, T-Deans) is a high-performance power pack created through a direct partnership between Specna Arms and industry-benchmark cell manufacturer Gens Ace. Engineered specifically for tight compartments in performance airsoft builds, it solves physical cabling bottlenecks while elevating trigger response and cycle consistency to competition standards.

Built on High Voltage (11.4V LiHV) chemistry, each cell charges up to 4.35V (compared to standard 4.2V LiPo cells), delivering superior initial voltage under load. Paired with a relentless 50C discharge rating, this battery feeds high-torque and brushless powertrains instantly, drastically shortening lock time on semi-auto and driving consistent cycle completion without bogging down on heavy springs.

The pack features shortened silicone lead wires, eliminating the struggle of tucking surplus wiring bundles inside M4 buffer tubes or compact RIS enclosures and preventing wire pinching when collapsing modular stocks. For ultimate ease and safety, the balance lead incorporates G-Tech smart chip technology: when connected to a compatible G-Tech charger, the unit is automatically identified within 5 seconds to select optimal charging parameters autonomously (also fully functional with standard LiHV balance chargers via standard balance routines).

• • Specna Arms x Gens Ace Partnership: Elite cell consistency, reliability, and high cycle endurance.

  • 11.4V High Voltage (LiHV): Enhanced motor RPM and immediate trigger break over 11.1V setups.

  • 50C High-Drain Output: Handles demanding high-speed, DSG, and brushless builds without voltage sag.

  • Smart G-Tech Plug: Automatically recognized by G-Tech chargers in 5 seconds for foolproof setup.

  • Shortened Wiring Harness: Minimizes clutter inside stocks and buffer tubes.

  • Factory T-Deans Terminal: Low-resistance connection with zero plug arcing.

• Technical Specifications:

Important LiPo Handling & Safety Guidelines:

• • Always disconnect after skirmishes: Disconnect the battery from the replica immediately after play; passive standby draw from electronic trigger units (ETU/MOSFET) can slowly cause critical under-voltage.

  • Voltage Thresholds: Never discharge cells below 3.0V (9.0V total cutoff) or overcharge beyond 4.35V per cell in LiHV mode. Over-discharging initiates destructive chemical degradation, swelling, and thermal runaway.

  • Charging Procedure: Charge using a dedicated microprocessor charger with LiHV balance support. G-Tech chargers auto-configure; on standard chargers, always connect both the main T-Deans leads and balance connector.

  • Seasonal Storage: If storing unused, balance charge the pack to storage level (Storage mode ~3.80–3.85V per cell, approx. 70% capacity). Never store completely flat or at 100% full capacity.